Service

FAQ

In the list below you can find the Frequently Asked Questions (FAQ) on a variety of our products. If the answer you are looking for cannot be found, then please contact our Service Department for furter information.

SMD board dipswitches and errors
Canister filling indications
Powerbox settings
POM agitator
Flatscreen Picture Improvement
Turntable motor for the Blendorama Tintmaster
Netvista Prisma instruction
Netvista Prisma Utility Disk
SLP installation
Training request form
Problems with PrismaPro in combination with an old PCB
Agitation controller
Canister replacement
Changing pump
Error 3020 HABA V30
Timesetting
Shaking stops after few seconds
Time setting
1602641-SP
Can stuck inside
E10 All solutions
Setting parameters
Spindel
CE-Conformity

---

SMD board dipswitches and errors
[5G] SMD Board.pdf

Canister filling indications
[All dispensers] Canister_Filling.pdf

Powerbox settings
[All dispensers] Powerbox settings.pdf

POM agitator
[All dispensers] POM agitator.pdf

Flatscreen Picture Improvement
Flatscreen JP8.pdf

Turntable motor for the Blendorama Tintmaster
[BT]_Turntable_motor.pdf

Netvista Prisma instruction
NetVista-Prisma_Instruction.pdf

Netvista Prisma Utility Disk
Util_Disk_FM.exe

SLP installation
[General] SLP installation.pdf

Training request form
Training request(1).doc

Problems with PrismaPro in combination with an old PCB
[HA-FA]_Old_PCB.pdf

Agitation controller
[HA-l] Agitation controller.pdf

Canister replacement
[HA-m] Canisters Replacement.pdf

Changing pump
[HA-s_HA-m] Changing pump.pdf

Error 3020 HABA V30
[HA-s_HA-m] Error 3020 HABA V30.pdf

Timesetting
[SO-20a] Timesetting .pdf

Shaking stops after few seconds
[SO-10m] Clampswitch.pdf

Time setting
[SO-20a] Timesetting .pdf

1602641-SP
[SO-40a] 1602641-SP.pdf

Can stuck inside
[SO-40a] Can stuck inside.pdf

E10 All solutions
[SO-40a] E10 All solutions.pdf

Setting parameters
[SO-40a] Setting parameters.pdf

Spindel
[SO-40a] Spindel.pdf

CE-Conformity
CE_Conformity_1.4_disp-shakers-mixers-v06-2010.pdf